UNMS - Roadmap


In this article we will show a roadmap for UNMS.

NOTE:Content listed here is based on our Community feature requests.

Table of Contents

  1. Introduction
  2. Upcoming Features
  3. Related Articles


Back to Top

We have opened UNMS development to the feedback of our community as much as possible. For that reason, it is paramount for us to hear your feature requests and allow you to influence our plans for new features accordingly. We prioritize on those requests that are most desired by the community so here is a short list of those. 

Upcoming Features

Back to Top

NOTE: Planned featuresin the table below are ordered neither by importance nor by the expected time of implementation.

Our top priority is to complete support for all Ubiquiti devices. Here is a table showing, what is already done and what needs to be added. We are committed to listen to your feedback and drive the development of UNMS in a direction that our community will appreciate. For that, we would like to encourage you to express your desires in our feature request section.


For airMAX and airCube devices in AP mode, we will show more detailed info about connected clients. You will be able to investigate any client issues much more effectively with this feature.




Submitted By

(First gen. already available in 1.1.0)

UNMS will be integrated with AirLink. This will allow you to easily plan new connections and simulate the coverage of an area with Ubiquiti devices. This solution will provide a clear view of your network topology on a satellite map background, showing all your AP, stations, clients and datalinks.


Parallel FW upgrade
(First gen. already available in 1.1.0)

Smart FW upgrade for APs and their stations together. This feature will allow scheduling FW upgrade as well. The mass parallel upgrade will be able to evaluate the structure of a site and recognize if a device is providing energy to other devices through PoE. This is necessary to prevent a restart of any device in the middle of an upgrade.



Real-time analysis and evaluation of issues in your network. Each discovered issue is immediately followed by an alert. This system will be able to recognize the wide scale of issues: outages, signal strength, capacity overload, configuration mistakes etc...



Advanced system for roles and multi-tenancy. This feature will allow restricting access to specific sites/clients for particular users.



IP management

Subsystem for IP management. This feature allows attaching a specific IP address to any device. UNMS will not only offer a list of all used IP addresses, but it will be able to assign IP addresses to devices according to business requirements of UCRM as well. Also, the new smart installation wizards in the UNMS mobile app will be dependent on this feature to work properly.


Firewall configuration

On EdgeRouters it will be possible to configure selection of the most important firewall settings remotely from UNMS.



Full support of IPv6 protocol everywhere in UNMS. UNMS will be able to run on IPv6 server, connect devices from IPv6 networks and correctly display and manage IPv6 addresses.


Site survey

UNMS will be able to scan nearby networks for all wireless airMAX and airCube devices. This feature will give you a useful overview of neighboring networks and their devices.


UniFi integration

This feature will allow connecting a whole UniFi network as a single UNMS device for simple monitoring only. It will not be able to manage the UniFi network in any way but we will add a one-click link to the UniFi controller.



VPN management

A configuration of VPN on EdgeRouters.


Related Articles

Back to Top

UNMS - Supported devices

Was this article helpful?
54 out of 64 found this helpful
Can't find what you're looking for?
Visit our worldwide community of Ubiquiti experts for more answers
Visit the Ubiquiti Community