Support Downloads Community

UniFi Video is an obsolete product line.

This application and its related devices will no longer receive any manner of technical support, including functional and security updates. Additionally, there will be no further updates to Help Center content pertaining to UniFi Video.

UniFi - Using VLANs with UniFi Routing Hardware

Overview

This article discusses how to use VLANs with UniFi Network routing products. Find a link to an introductory article on VLANs in the Related Articles below, as well as how to use VLANs on UniFi switching and wireless devices. 

Table of Contents

  1. UniFi Device Management
  2. How to Configure VLANs on UniFi Routing Devices
  3. Related Articles

UniFi Device Management

Back to Top

Begin by adopting the UniFi wireless device over the native, or untagged, VLAN. This will be the continued requirement. That being said, L3 management is supported, so the UniFi Network application can remote. See more about that in the UniFi - Layer 3 Adoption for Remote UniFi Network Applications article.

UniFi Network access points and switches can be set to tagged VLANs. After the device is adopted over the untagged VLAN, define a tagged management VLAN to use. This is found under the device Properties window (from the Devices page click on the device to reveal the Properties Panel). Select Config (gear icon) > Services > Management VLAN.

How to Configure VLANs on UniFi Routing Devices

Back to Top

The UniFi Security Gateway (USG) and UniFi Dream Machine (UDM and UDM-Pro) can be used to manage DHCP server, routing, and VLANs on networks. It would also use the Settings > Networks area to define subnets. A corporate network has no restrictions, whereas a guest network cannot communicate with other subnets on your network. The guest control settings are also applied to guest networks (i.e. wired guest portal).

The default physical LAN interface's network is, by default, using untagged VLAN 1. There can be multiple VIFs (virtual interface/VLANs) per physical LAN interface. The VLAN ID of the untagged subnet (it is 1 or 4010, depending on if it's LAN or VoIP subnet) cannot be edited. The settings window looks similar for both corporate and guest networks, so only a corporate network will be shown below. Basically, enter the desired IP with CIDR, and then choose the VLAN ID.

Related Articles

Back to Top

Intro to Networking - Introduction to Virtual LANs (VLANs) and Tagging

UniFi - VLAN Traffic Tagging

UniFi - Layer 3 Adoption for Remote UniFi Network Applications

 

UniFi - Using VLANs with UniFi Wireless

Was this article helpful?
141 out of 437 found this helpful