UniFi OS Consoles Wi-Fi Switching Camera Security Phone System Door Access Accessories UISP
Support Resources
UniFi Help Articles UISP Help Articles Video Tutorials Community Forums UniFi Design Center UISP Design Center RMA and Warranty Contact Support
Store
Support Resources
UniFi Help Articles UISP Help Articles Video Tutorials Community Forums UniFi Design Center UISP Design Center RMA and Warranty Contact Support
UniFi OS Consoles Wi-Fi Switching Camera Security Phone System Door Access Accessories UISP Store
  1. Ubiquiti Support and Help Center
  2. UISP
  3. UISP Routing and Switching
  4. EdgeSwitch
  5. EdgeSwitch XP
Help Center
Back to Top

EdgeSwitch XP - Enable Passive PoE Output

2023-02-13 22:57:00 UTC

Overview

Readers will learn how to enable Passive PoE output on the interfaces of an ES-XP.

NOTES & REQUIREMENTS:
Applicable to the latest EdgeSwitch XP firmware on the following models:
  • ES-5XP
  • ES-8XP
  • ES-16XP
Device used in this article:

How to enable the PoE Output

Back to Top

GUI: Access the ES-XP Web UI.

1. Navigate to the Dashboard  dashboard.png  tab.

2. Select the Configure  settings.png  option to enter the Advanced settings for a port.

3. Change the PoE mode by choosing between the following options (depending on the ES-XP model):

  • Off No PoE output.
  • 24V Passive PoE output using 24V.
  • 48V Passive PoE output using 48V.
WARNING:Make sure that a compatible PoE device is plugged into the port before enabling the Passive PoE output.

4. Apply the changes by clicking on the SAVE button.

Was this article helpful?
23 out of 37 found this helpful