×

EdgeRouter - SNMP

Overview

Readers will learn how to enable and configure the Simple Network Management Protocol (SNMP) on an EdgeRouter.

NOTES & REQUIREMENTS:
Applicable to the latest EdgeOS firmware on all EdgeRouter models. Please see the Related Articles below for more information.
Device used in this article:

Configuring SNMP using the Command Line

Back to Top

CLI: Access the Command Line Interface.You can do this using the CLI button in the GUI or by using a program such as PuTTY.

1. Enter configuration mode.

configure

2. Define the SNMP community name and set the authorization mode (replace <community> with your desired community name).

set service snmp community <community> authorization ro
NOTE: Theauthorization ro option indicates that the community is read only.

3. Commit the changes and save the configuration.

commit ; save

The EdgeRouter also allows you to customize the SNMP settings. The available options are:

set service snmp community <community> client <ip-address>
set service snmp description <description>
set service snmp location <location>
set service snmp contact <name>
set service snmp trap-target <ip-address>
set service snmp listen-address <ip-address>

Related Articles

Back to Top

EdgeRouter - How to Access the EdgeRouter

EdgeRouter - Access the CLI from the Web UI

EdgeRouter - Configuration and Operational Mode

Intro to Networking - How to Establish a Connection Using SSH

Was this article helpful?
2 out of 8 found this helpful
Can't find what you're looking for?
Visit our worldwide community of Ubiquiti experts for more answers
Visit the Ubiquiti Community