Support Downloads Community

UniFi Video is an obsolete product line.

This application and its related devices will no longer receive any manner of technical support, including functional and security updates. Additionally, there will be no further updates to Help Center content pertaining to UniFi Video.

EdgeSwitch XP - Enable Passive PoE Output using the Command Line

Overview

Readers will learn how to enable Passive PoE output on the interfaces of an ES-XP using the command line.

NOTES & REQUIREMENTS:
Applicable to the latest EdgeSwitch XP firmware on the following models:
  • ES-5XP
  • ES-8XP
  • ES-16XP
Device used in this article:

How to enable the PoE Output using SSH

Back to Top

CLI: Access the command line interface (CLI). You can do this by using a program such as PuTTY.

1. Choose between the following PoE mode options (depending on the ES-XP model):

  • Off No PoE output.
  • 24V Passive PoE output using 24V.
  • 48V Passive PoE output using 48V.

2. To enable Passive PoE output on Port 1 using 24V, run the following command:

poe 1 24

3. To disable Passive PoE output on Port 1, run the following command:

poe 1 0
WARNING:Make sure that a compatible PoE device is plugged into the port before enabling the Passive PoE output.
Was this article helpful?
5 out of 9 found this helpful