×

EdgeRouter - Built-in Dynamic DNS

Overview

Readers will learn how to configure Dynamic DNS on the EdgeRouter using the built-in services.

NOTES & REQUIREMENTS:
Applicable to the latest EdgeOS firmware on all EdgeRouter models. Please see the Related Articles below for more information.
Device used in this article:

Configuring the Built-in Dynamic DNS Service

Back to Top

The following Dynamic DNS services are available for use in EdgeOS:

  • Afraid Requires server to be hard-coded.
  • Dnspark
  • Dslreports
  • dyndns
  • Easydns
  • Namecheap
  • Noip
  • Sitelutions Requires serial number to be set as the hostname.
  • Zoneedit

See the Custom Dynamic DNS article for instructions on how to configure a custom Dynamic DNS service.

CLI: Access the EdgeRouter Command Line Interface.

1. Enter configuration mode.

configure

2. Add the Dynamic DNS service and the login credentials.

set service dns dynamic interface eth0 service <dyndnsservice> host-name <host>
set service dns dynamic interface eth0 service <dyndnsservice> login <username>
set service dns dynamic interface eth0 service <dyndnsservice> password <password>

3.  Configure the location of the Dynamic DNS server.

set service dns dynamic interface eth0 service <dyndnsservice> server <server>
NOTE: This step is required when using afraid.org.

4. Commit the changes and save the configuration.

commit ; save ; exit

You can verify the status and force an update of the Dynamic DNS service using the commands below:

show dns dynamic status
update dns dynamic interface <interface-name>

By default, EdgeOS will only update Dynamic DNS when the IP address actually changes.

Related Articles

Back to Top

EdgeRouter - Custom Dynamic DNS

Intro to Networking - How to Establish a Connection Using SSH

Was this article helpful?
19 out of 32 found this helpful
Can't find what you're looking for?
Visit our worldwide community of Ubiquiti experts for more answers
Visit the Ubiquiti Community